Step2: Slave Cylinder
Page 1 of 1
Step2: Slave Cylinder
Installation of Slave Cylinder.
http://stalkercars.com/Build_Videos/V8/slavecylinder.wmv
After locationg where the lines will come out of the bell housing. Use a step drill or hole saw to make a hole for the bleed line to exit.
The clutch kit for the 3800 will NOT have a spacer.
http://stalkercars.com/Build_Videos/V8/slavecylinder.wmv
After locationg where the lines will come out of the bell housing. Use a step drill or hole saw to make a hole for the bleed line to exit.
The clutch kit for the 3800 will NOT have a spacer.
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|